【概要描述】The rapid development trend of social and economic development, heating furnace is widely used in the manufacturing of each manufacturing industry, waste heat boiler as a kind of heating furnace, but there is no natural material ignition equipment, it has other heating furnace does not have the characteristics, then the principle of waste heat boiler is how, waste heat boiler start to pay attention to what problems, the following to the big guys to explain in detail.
The use of high temperature waste heat recovery of organic waste gas is generally waste heat generation. Considering the manufacturing must, in order to prevent the heating furnace stop using, repair endangering manufacturing, generally have a bypass exhaust flue and auxiliary smoke tube, when the waste heat power generation, turn off the bypass exhaust flue, its soot into the waste heat boiler, soot steps are as follows: high temperature soot a soot spacer a high temperature heating surface a super low temperature heating surface a convection tube bundle (air conditioning evaporator) a boiler energy saver a dust removal equipment a centrifugal fan a main smoke tube
Start and stop more often, the heating surface due to frequent overheating material changes, resulting in lower compressive strength, operation will appear deformation and burst conditions. Therefore, this kind of waste heat boiler starting method is different from the general use of ultra-low temperature organic waste gas waste heat boiler, start, to prevent the heating surface overheating becomes the first problem to deal with.
Start-up method to prevent overheating of the heating surface
In the start, the heating surface will be full of oil and water, in the whole process of starting, because of the heating effect of high-temperature organic waste gas, so that the water in the heating surface is slowly heated gasification, high-temperature organic waste gas by the heating surface after cooling, into the convection tube bundle (air conditioning evaporator) area, so that the volatile encounter with the water in the heating surface is slowly heated. With the increase of time, the heated surface of the original water all become steam, and outward discharge, and the volatile encounter surface of the water also just began to cause steam, and according to the furnace wall, steam guide tube into the heated surface, starting the whole process into the basic heating furnace all normal starting situation.
This starting method, the use of water and water heat absorption reaction caused by the vapor cooling heated surface, reduce the wall temperature of the heated surface to start, the way effective. However, after the evaporation of water, the residue of the melting in the water will dissolve and settle on the wall thickness of the heated surface, start more often, when the accumulation of thickening, will cause the wall temperature of the heated surface all normal operation is high, unfavorable to the safe operation of the heated surface. Therefore, the choice of this method, the water body regulations are very high.
Recently, the Guangdong Provincial Quality Supervision and Inspection Bureau held a validation meeting of the Guangdong Provincial Local Standard “Industrial Boiler Water Treatment Design Guidelines”MORE +
On September 26, the coal-fired brown coal transformation project of the No. 2 unit of China Power Investment Corporation was officially started. This work is the most important work of the company beMORE +
Promote the use of clean energy and low-sulfur fuels It is reported that the Municipal Environmental Protection Bureau has carried out investigations and demonstrations on the causes and countermeasurMORE +
Promote the use of clean energy and low-sulfur fuel It is reported that the city's Environmental Protection Bureau, through research and demonstration of the causes of haze and countermeasures, has deployed a special remediation of haze action, aimed at allowing citizens to breathe fresh air. From this month until the end of June, the relevant departments will focus on the city's more than 150 boilers to improve the use of clean energy and low-sulfur fuels to reduce smoke and exhaust emissions. Reporters learned that in the process of rectifying coal-fired boilers, the city's environmental protection departments will be the city's coal-fired, coal-fired water slurry, heavy oil-fired, biomass-fired forming pellet boilers to check the registration, a comprehensive survey to collect the basic information on the use of boilers.MORE +
Tan Tou Industrial Zone, Guijiao Avenue, Guicheng, Nanhai District, Foshan City, Guangdong Province
Website QR Code
Add WeChat contact